Advertisement
Installation Procedure for the Upgrade
Step 19. Assemble the A33 - A36 Test Port Coupler Assemblies
1. Remove the A33 test port 1 coupler and A36 test port 2 coupler from the
2. Using pliers, remove the adhesive bumper on the A33 test port 1 coupler
3. Follow the two instructions shown in
Figure 6
A33 - A36 Test Port Coupler Assembly
Step 20. Install the LED Boards and Test Port Coupler Assemblies to
the Test Set Front Plate
1. Remove two screws from each LED board and remove the boards from the
22
PNA. For instructions, click the Chapter 7 bookmark, "Removing and
Replacing the A33 - A36 Test Port Couplers" in the PDF Service Guide
and on the A36 test port 2 coupler.
Table 1 on page 9
of this document.
2-port test set front plate of the PNA.
1. See
"Downloading the Online PNA Service Guide" on page
Figure
6. New parts are listed in
6.
Installation Note N5245-90121
1
.
Advertisement
