Installation Tips; Maintenance Tips; Safety Tips - BEA LZR-FLATSCAN REV-LZ User Manual

INSTALLATION TIPS

Remove the laser window
protection before
the teach-in and the
commissioning of the
sensor.
Avoid the presence
of smoke and fog in
the detection field.

MAINTENANCE TIPS

When needed, wipe
the laser window only
with a soft, clean and
damp microfibre cloth.

SAFETY TIPS

The door control unit
and the door cover
profile must be correctly
earthed.
• The device cannot be used for purposes other than its intended use. All other uses cannot be
guaranteed by the manufacturer of the sensor.
• The manufacturer of the door system is responsible for carrying out a risk assessment and installing the
sensor and the door system in compliance with applicable national and international regulations and
standards on door safety.
• The manufacturer of the sensor cannot be held responsible for incorrect installations or inappropriate
adjustments of the sensor.
2
Avoid vibrations.
Avoid condensation.
Do not use dry or dirty
towels or aggressive
products to clean the
laser window.
Only trained and
qualified personnel may
install and setup the
sensor.
Do not cover
the laser window.
Avoid exposure to
sudden and extreme
temperature changes.
Avoid direct exposure
to high pressure
cleaning.
Always test the good
functioning of the
installation before leaving
the premises.
Avoid moving objects
and light sources in
the detection field.
Keep the sensor permanently
powered in environments
where the temperature can
descend below -10°C.
The warranty is invalid if
unauthorized repairs are
made or attempted by
unauthorized personnel.
Do not remove the laser
window protection if
building works are still
in progress on site.