BEA LZR-FLATSCAN REV-LZ User Manual page 11

IMMUNITY FILTER
UNCOVERED ZONE
ANTIMASKING &
BACKGROUND
GENERAL
FACTORY VALUE
In order to change these settings by remote control, adjust DIP-switch 2 to ON
low >
Increase to filter out external disturbances.
The reaction time increases significantly between value 5 and 9.
In order to change these settings by remote control, adjust DIP-switch 2 to ON
2 4
Increase in case of snow, dead leaves, etc.
* Measured in specific conditions and dependant on application and installation.
In order to change these settings by remote control, adjust DIP-switch 3 to ON
ANTIMASKING OFF
BACKGROUND
OFF
Antimasking: protective function which detects an unwanted object nearby the laser
window masking the vision field.
Background: reference point in the detection field of the sensor.
If no background is present, switch to off.
teach-in
See page 8
> > > >
6 8 10 12
ON
OFF ON
ON
OFF
ON
full reset
Factory reset
of all values
> > high
14 16 18 cm
*
partial reset
Factory reset
of all values exept field
dimensions and
output configurations
11