BEA LZR-FLATSCAN REV-LZ User Manual page 5

5
Using a wire cutter, remove the positioning aids from
the base.
We provide two cabling modes (1a or 1b), please process following steps according to the site condition.
1a
HIDE CABLE INSIDE THE SENSOR
1
Ø 10 mm Ø 10 mm
Drill through the base and the door using a 10 mm bit
in order to pass the cable.
Soften the edges using a sheet of sandpaper.
3
Take the sensor and remove the cover: put your
finger in the hole and pull firmly towards you in one
movement.
6
Fasten the 3 screws using a Pozidrive screwdriver.
The base needs to be fixed firmly!
2
Take the cable and pass it through the hole. Position
the cable in the notch of the base and make sure it is
firmly fixed.
4
Pass the cable through the hole on the back of the
sensor and fasten the sensor on the base by sliding it
downwards.
5