BEA LZR-FLATSCAN REV-LZ User Manual page 8

3
DIP-SWITCH 1
Make sure the setting of DIP 1 is correct.
Standard Mode
ON
ON
1 2 3 4
Output from R1, red LED flashes
when there is a detection.
(Recommend Mode）
Custom Mode
OFF
ON
1 2 3 4
Output from R2, green LED
flashes when there is a detection.
ORANGE GREEN
> 3 sec.
4
4
TEACH-IN
Before launching a teach-in, make sure that:
- glass surfaces near the door are covered
- the door controller is set up first
- the detection field is free of snow buildups, heavy rain, snowfall, fog or other objects or people
- the laser window protection is removed.
1. To launch a teach-in, press the push button briefly. The LED starts to flash red-green quickly.
2. Wait until sensor flashes green quickly. Position yourself in front of the door and stretch out your arm in front
of you. Make an up and down movement in front of the moving edge level in order to mark the limit of the
detection zones. The LED flashes red while calculating the width of the door wings.
• Standard Mode*: The LED starts to flash red, then green slowly, next the red, no need to do anything during
3.
this process ( Make sure you're outside of the detection field ), wait until the LED is off, the teach-in is completed.
• Custom Mode: The LED starts to flash red, then green slowly, then move your hand to define the detection
field as your request, next LED flashes red. ( Make sure you're outside of the detection field ), wait until the LED is
off, the teach-in is completed.
1.
< 1 sec.
* The default mode is Standard Mode.
8
A rectangle shape can be traced in the detection area during the learning
process of 30 seconds.
A custom shape can be traced in the detection area during the learning
process of 30 seconds.
After changing a DIP-switch, the orange LED flashes. A LONG push on the push
X
button confirms the settings.
OFF
TEACH-IN PROCESS
2. FIELD WIDTH
30s
30s
3. TEACH-IN
FACTORY VALUE