Table of Contents
Advertisement
INSTALLATION LOCATION TIPS
Detection area (location)
The threshold (i.e. counting area) should be appropriately covered. Measure the
desired threshold width across the space in front of the entrance (this is the space that
people will walk through). Beware of creating detection zone that is too wide, as you
could mistakenly be set up to count more than what is intended.
Proximity to door
The sensor should always be center-mounted above the desired detection zone (exception:
See Swing Doors section), and as close to the entryway as possible while avoiding
obstructions (ideally, no more than 12" from the threshold).
Corridor mounting
When the application calls for mounting in a corridor or hallway, you may
mount away from the door as long as the entire width of the corridor can be
covered by the laser field.
Sensor directionality
Observe the "A" and "B" markings on the sensor.
When wall mounting (or ceiling mounting near a wall), direction A must be pointing away
from the wall.
©BEA
| Original Instructions
75.5929.01 LZR-SIGMA 20210630
HOW IT WORKS
A
H
W
TOP VIEW
ENTRANCE
max 12"
Scan
me to
start
X0006F
Page 7 of 17
Advertisement
Table of Contents
