Camera - FLASHFORGE 3D PRINTER Inventor II S User Manual

7.3 Camer a
7.3.1 Connect fr om Polar Cloud
For detailed connection method，please refer to 7.2.5
After InventorIIS printer has added to Polar Cloud account and connected successfully
(InventorIIS printer and your computer should link to Internet by WiFi, printer and
computer do not need to connect the same WiFi signal), Then InventorIIS printer's
camera can be used to monitor the real-time printing status.
This function is valid in FlashForge Cloud for now or later: please refer to 7.2.4
After InventorIIS printer has added to FlashForge Cloud account and connected
successfully (InventorIIS printer and your computer should link to Internet by WiFi,
printer and computer do not need to connect the same WiFi signal), Then InventorIIS
printer's camera can be used to monitor the real-time printing status.
7.3.2 Dir ect Connect fr om computer
1) Connect your InventorIIS printer and your computer to a same WIFI signal.
2) Install and start up Firefox browser(software) on your computer, type in the
following address as the format showed below, then you can monitor the real-time
printing status by the camera.
http://192.168.1.111:8080/?action=stream
（ 192.168.1.111 is your printer's present IP address, this address must be edited
according to your printer IP address showed on printer touch screen.）
73
InventorIIS User Guide | www.flashforge.com