hajdu ZV80ErP Installation And Owner's Manual page 26

EN
6.4. To perform electric connection, take out the screws of the cover of the
fitting house and remove the cover, so that the electric fittings can be
accessed.
The electric connection wire has to be connected to the screwed connecting
points of the temperature controlling/reducing device.
The protective conductor (green and yellow) has to be connected to the
earthing screw of the closing cover. The stripped wire end is placed under
the earthing washer and it is mounted with spring washer and screw nut.
The electric connection outline drawing can be seen on Figure 3. which can
also be seen on the cover of the fitting house.
6.5. The connecting wire has to be discharged with fixing the carriage at lead-
In after electric connection.
Touch protection class of the appliance: I.
The covers closing electric accessories provide suitable protection against
accidental touch of active electric parts being under power during operation.
Please, connect the appliance to the electric network according to the
connection diagram located both on the bottom sheet and in the usage
manual of the appliance. IT IS AT THE RISK OF DEATH AND THEREFORE IT IS
FORBIDDEN to install and operate the appliance without professional
connection of touch protection wire!
It is proposed to apply touch protection relay in the electric network of the
establishment to operate the appliance adequately.
6.6. It is forbidden to operate the hot water tank without any protective
earthing. The protective earthing has to comply with the instructions of the
Standard IEC 60364.
7. PUTTING INTO OPERATION
After installation, the hot water tank can be put into operation. Please turn to
a professional technician to control correct operation at the first operation.
7.1. Open the closing valve (Figure 2., item No. 1) and the hot water faucet but
keep the cold water faucet closed. The water flowing in fills up the water tank.
26