S-Registers - Multitech CC1600 Series Owner's Manual

Password Commands
COMMAND:
VALUES:
DEFAULT:
DESCRIPTION:
COMMAND:
VALUES:
DEFAULT:
DESCRIPTION:
4.2

S-Registers

Certain Command Mode configurations are stored in memory registers called, S-Registers. The S
command is used to assign a value to, and to read the current value of an S-Register. To assign a
value to an S-Register, enter the letter S, followed by the S-Register number and an equals sign (=),
and then a decimal response to the message "ENTER THE NEW VALUE IN DECIMAL FORMAT".
To read an S-Register value, enter the letter S followed by the S-Register number and a question
mark (?), then hit RETURN. To verify that the S-Register value was entered correctly, enter for
example, ATS8? and hit RETURN. You should receive a response of the assigned value given to
that S-Register.
S0
Number of Rings Until Modem Answers
Unit:
Range:
Default:
Description:
S1
Rings Which Have Occurred
Unit:
Range:
Default:
Description:
S2
Escape Code Character
Unit:
Range:
Default:
Description:
S3
Return Character
Unit:
Range:
Default:
Description:
Chapter 4 - Modem Commands, S-Registers & Result Codes
#Ixxxxxxxxxx
n/a
#IMULTITECH
Login Password is any keyboard characters (x) (upper/lower case
sensitive), minimum 6 and maximum 10 characters. The default
Login Password is MULTI-TECH.
#Syyyyyyyyyy
n/a
#SMODEMSETUP
Set-up Password is any keyboard characters (y) (upper/lower case
sensitive), minimum 6 and maximum 10 characters. The default
Set-up Password is MODEMSETUP.
1 ring
0-255
1
Sets the number of rings before the modem answers.
1 ring
0-255
0
Counts the number of rings that have occurred.
ASCII Character
0-127
43 (+ sign)
Defines the escape code character.
ASCII Character
0-127
13
Defines the character recognized as Carriage Return (RETURN) or "Enter".
45