Safety And Warnings; Usage; Parts List - Uplift Desk 2-Leg Side Table Directions For Assembly And Use

1. SAFETY AND WARNINGS

When using an electrical furnishing, basic precautions should always be followed, including the following:
Read all instructions before using the table.
FAILURE TO COMPLY WITH OR OBSERVE ALL ASSEMBLY, SAFETY, AND OPERATION INSTRUCTIONS
AND WARNINGS REGARDING THE USE OF THIS PRODUCT MAY RESULT IN SERIOUS PROPERTY
DAMAGE OR BODILY INJURY.
WARNING - To reduce the risk of injury to persons, or property damage:
• Close supervision is necessary when this furnishing is used by, or near children, invalids, or disabled
persons.
• Use this table only for its intended use as described in these instructions. Do not use attachments
not recommended by the manufacturer.
• Do not use outdoors.
• Inappropriate use of this product may cause property or bodily injury.
• Please provide this manual to any users, installers, or support personnel using the product.
• If casters are not installed, use a two-person lift and lift the table so that it can be moved without
dragging. Dragging the table may cause the frame and screws to pull loose from the desktop.
• Maximum weight capacity of this product is 355 Ib. Do not overload your table.

2. USAGE

This table is designed for use in dry work areas only. These tables are designed only for the purposes
included in this manual. They should not be used in environments with high humidity or dampness.
Any other use is at user's risk.
Do not sit or stand on the table frame.
Children should never use the table unless they are supervised by adults.
Liability: Under no circumstances does the manufacturer accept warranty claims or liability claims for
damages caused from improper use or handling of the table frame other than that which is described
in this operation manual.

3. PARTS LIST

Leg
1
(qty 2)
Side bracket
5
(qty 2)
M6x10
9
Machine screw
(qty 8)
2
© UPLIFT Desk • 1-800-349-3839 • info@upliftdesk.com • www.upliftdesk.com
Components
Foot
2 3
(qty 2)
Adhesive pads
6 7
(qty 10)
#10x5/8''
10 a
Wood screw
(qty 12)
Crossbar end Crossbar rail
4
(qty 2) (qty 2)
Leveling stud M6x14
8
(pre-installed, qty 4) Machine screw
(qty 24)
#10-24x5/8''
10 b
Machine screw
(qty 8)
Tools required
Allen wrench
(included)
Tape Measure
Philips Head Screwdriver
and/or Power Drill