Labconco Protector Echo 180 Series User Manual page 36

Original instructions
Step 3 – Remove front panel.
Use your ladder and remove the upper front panel so you can access the RFID
filter tags later in this procedure.
Step 4 – Delete current configuration.
You should now see on the screen:
>Hood Status
Administration menu
Maintenance menu
Arrow down to
You should now see:
>Hood Integration
Semicon S. Alarm Delay
Electro S. Alarm Delay
Sash Sensor Trig.
Software Releases
Audible Alarm Mgmt.
"Hood Integration"
At
Then arrow down to
You should now see
from the right.
"0000000000"
Now arrow up once to make a
Arrow up twice to make a
Arrow up three times to make a
Arrow up four times to make a
You will now have
***Note if you make a mistake you can press
change the entry.***
If it is correct then press
You should now see
Product Service 1-800-522-7658
"Maintenance Menu"
"Ok."
press
"Delete Factory Cfg"
"0000000000."
Press
"1"
press
"2"
press
"3"
press
"4."
"0000001234."
"OK."
"Hood will reboot please be patient."
Chapter 3: Getting Started
"Ok"
then press to select it.
"Ok."
and press
"Ok"
until the cursor is on the fourth zero
"Ok."
"Ok."
"Ok."
"X"
to move back to the left and
31