S Parameter Syntax; Extended Syntax; Combining At Commands On The Same Command Line; Entering Successive At Commands On Separate Lines - Quectel M10 At Command Set

M10 AT Commands Set
the value of "<n>". "<n>" is optional and a default will be used if missing.

1.3.2 S parameter syntax

These AT commands have the format of "ATS<n>=<m>", where "<n>" is the index of the S
register to set, and "<m>"is the value to assign to it. "<m>" is optional; if it is missing, then a
default value is assigned.

1.3.3 Extended Syntax

These commands can operate in several modes, as following table:
Table 1: Types of AT commands and responses
Test Command
Read Command
Write Command
Execution Command

1.3.4 Combining AT commands on the same Command line

You can enter several AT commands on the same line. In this case, you do not need to type the
"AT" or "at" prefix before every Command. Instead, you only need type "AT" or "at" at the
beginning of the Command line. Please Note to use a semicolon as Command delimiter.
The Command line buffer can accept a maximum of 256 characters. If the characters entered
exceeded this number then none of the Command will be executed and TA will return "ERROR".

1.3.5 Entering successive AT commands on separate lines

When you need to enter a series of AT commands on separate lines, please Note that you need to
wait the final response (for example OK, CME error, CMS error) of last AT Command you entered
before you enter the next AT Command.

1.4 Supported character sets

The M10 AT Command interface defaults to the IRA character set. The M10 supports the
following character sets:
•
GSM format
•
UCS2
•
HEX
M10_ATC_V1.01
AT+<x>=? The mobile equipment returns the list of parameters
and value ranges set with the corresponding Write
Command or by internal processes.
AT+<x>? This command returns the currently set value of the
parameter or parameters.
AT+<x>=<...> This command sets the user-definable parameter
values.
AT+<x> The
parameters affected by internal processes in the GSM
engine
execution command reads non-variable
- 10 -