At+Qimode Select Tcpip Application Mode; At+Qitcfg Configure Transparent Transfer Mode - Quectel M10 At Command Set

M10 AT Commands Set
Reference Notice: The execution command only save the corresponding parameters
of the foreground context (refer to AT+QIFGCNT).

7.2.21 AT+QIMODE Select TCPIP Application Mode

AT+QIMODE Select TCPIP Application Mode
Test Command Response
AT+QIMODE=? +QIMODE:(0-NORMAL MODE,1-TRANSPARENT MODE)
OK
Read Command Response
AT+QIMODE? +QIMODE: <mode>
OK
Parameter
See Write Command
Write Command Response
AT+QIMODE=< OK
mode> ERROR
Parameter
<mode> 0
Reference Note

7.2.22 AT+QITCFG Configure Transparent Transfer mode

AT+QITCFG Configure Transparent Transfer Mode
Test Command Response
AT+QITCFG=? +QITCFG: (NmRetry:3-8),(WaitTm:2-10),(SendSz:256-1024),(esc:0,1)
OK
Read Command Response
AT+QITCFG? +QITCFG: <NmRetry>,<WaitTm>,<SendSz>,<esc>
OK
Parameters
See Write Command
Write Command Response
AT+QITCFG=< OK
NmRetry>,<Wai ERROR
tTm>,<SendSz>, Parameters
<esc> <NmRetry>
<WaitTm>
M10_ATC_V1.01
normal mode
1 transparent mode
number of retries to be made for an IP packet.
number of 100ms intervals to wait for serial input before
sending the packet.
- 153 -