Seat ALTEA FREETRACK Owner's Manual page 146

144 Seats and storage
Multi-purpose mobile storage compartment* - Fitting and
removal
This storage compartment may only be placed in the central
area of the rear seat
Fitting mobile storage compartment
– Fold down the small section of the rear seat backrest, in order
to access the large section of the backrest.
– Fit the mobile storage compartment mounting plate
⇒ F ig. 111
of the seat. It should be fitted between the backrest and the
seat, in the central seat area.
– Push the plate until it clips the cushion frame. The rings of the
mobile storage compartment mounting plate appear at the front
of the seat.
– If it is difficult to make the plate clip, tilt the rear backrest of the
large section forwards slightly and then lean the backrest back-
wards to make the fitting of the mobile storage compartment
onto the mounting plate easier.
Fig. 110 Mobile storage
compartment. Installa-
– Place the mobile storage compartment onto the foam of the
tion
central seat.
– Set both mounting pieces together
mounting rings
clips completely connect with the rings.
Removing mobile storage compartment
– Pull each of the buttons
forwards, until they snap out of place.
– Fold the larger seat down and remove the mobile storage com-
partment mounting plate.
Fig. 111 Mobile storage
compartment mounting
plate
from the inside of the vehicle, through the rear part
⇒ F ig.
110, with both
E
⇒ F ig. 111
and press hard until both the
G
⇒ F ig. 110
on the clips (red buttons)
F
H
