276
If and when
Towline anchorage
Fitting the towline anchorage
– Take the towline anchorage from the on-board tool set.
– Remove the front cover by pressing down on its left-hand side.
– Remove the rear cover by pressing down on the right hand side.
– Screw the towline anchorage as shown by the arrow anticlock-
wise to the limit position in the front
⇒ F ig. 199
Fig. 198 The front right
section of the vehicle:
Fitting the front towline
anchorage
Fig. 199 Fitting the tow-
line anchorage to the rear
of the vehicle
⇒ F ig. 198
threaded hole.
or rear