Chapter 4 - Display Calibration - Garnet SEELEVEL II 714 Manual

CHAPTER 4 - DISPLAY CALIBRATION

To display code revision number and display primary/
secondary status, and for setting display options:
1. Press and hold the bottom button and then the top button.
2. The display will show "COd rEL 3.11 Pri/SEC Scn". This shows
the code release as 3.10 and whether the display is set as
primary or secondary.
3. If the buttons are held down for ~5 seconds, the display
shows "SEt dIS PLY OPt ion", release both buttons.
4. The display will show "tE1 tE2 LPG bAt dun". This represents
the options temperature 1, temperature 2, LPG, battery
voltage and done. If an option is not currently turned on it
will not show.
5. Press the button next to each option to toggle it on and off.
When the option is off it disappears.
6. When the correct configuration is displayed press the button
next to "dun" to store and exit.
To calibrate the temperature readouts to degrees F or
degrees C:
1. Press and hold the bottom button and then the third button.
2. The display will show either "Set TEP F-C t-C dun" or "Set TEP
F-C t-F dun" depending on whether degrees F or C is currently
shown. When this occurs release the buttons.
3. To alternate between Fahrenheit and Celsius, press any of the
top four buttons, each time a button is pressed the display will
switch to the other temperature.
4. When the display shows the correct temperature mode, press
the bottom button, "Sto" will be displayed to indicate that the
temperature unit has been stored.
To calibrate the display as primary or secondary:
1. This should only be done at the time of installation. This only
needs to be calibrated if there are two displays connected to
the senders.
2. With no power to the display, hold down the bottom and
second buttons. Reconnect power, the display will show "SEt
Pri or SEC Scn." After holding the button for about 5 seconds
the display will show either "Pri Scn
When this occurs release both buttons.
Page 6
dun" or "Sec Scn
714 / 714-P Manual
dun".