Chapter 3 - Operating Instructions - Garnet SEELEVEL II 714 Manual

CHAPTER 3 - OPERATING INSTRUCTIONS

T
he display is the only system component that is accessed by
the user. Operation of the display is as follows:
To read a tank level:
The levels in percent are continuously shown on the LED displays,
and are updated every 10 seconds. If more frequent updates are
required (~2 seconds) while loading or unloading a tank, the tank
can be put into hold mode by pressing the button for that tank. A
display in hold mode is shown by the decimal in the bottom right
corner of the readout. Hold mode for a tank is only available on
the primary display.
To read the outside temperature:
The temperature in degrees is continuously shown on the LED
display, and is updated every 10 seconds. If there are 2 temperature
senders installed, then pressing the button to the right of the
temperature display will toggle between the two temperatures.
The second temperature will be indicated by a decimal point on
the right. The temperature can be programmed to be in either
degrees Celsius or Fahrenheit. Refer to the programming section
to obtain instructions on how to set this.
To read the battery voltage or LPG:
The fifth display can be toggled between battery voltage and LPG
tank level. The bottom button can be pressed to change between
battery voltage and LPG level. Battery voltage will be shown with
a decimal point and LPG level will not.
714 / 714-P Manual
Page 5