Dimmer; Back Light; Fixture Information; Temperature - ProLights DISPLAYCOBTRWDWW User Manual

14

3.13 DIMMER

• To enter dimmer mode and choose to simulate different dimming curves, press the MENU button re-
peatedly until the display shows Dimmer Mode, then press the ENTER button.
• Press the button MENU repeatedly until Dimmer Mode shows, and press ENTER button to accept.
• Use the button UP/DOWN to select a dimmer curve Off - Dimmer1 - Dimmer2 - Dimmer3.
• Press ENTER button to confirm the selection.
• Press the MENU button to go back or to meet the waiting time to exit from the setup menu automatically.

3.14 BACK LIGHT

• To activate backlight display press the button MENU so many times until shows Back Light, and press the
button ENTER to confirm.
• Press the button UP/DOWN to select On - 10S - 20S - 30S. Press ENTER button to confirm the selection.
• Press the MENU button to go back or to meet the waiting time to exit from the setup menu automati-
cally.

3.15 FIXTURE INFORMATION

1. Press the MENU button so many times until shows Information, and then press ENTER button.
2. Use UP/DOWN button to select: Auto Test - Fixture Hours - Version.
3. Press ENTER button to confirm the selection.
4. Press the MENU button to go back or to meet the waiting time to exit from the setup menu automatically.
Fixture Hours
This option shows the user the amount of hours the DISPLAYCOBTRWDWW has been in use through-
out its lifetime. Select Fixture Hours.
Version
This option shows the user the software version currently installed in the unit. Select Version.

3.16 TEMPERATURE

• To read the value of the internal temperature of the device, press the MENU button repeatedly until the
display shows Temperature, and then press the ENTER key to read the value.
• Press the MENU button to go back or wait a few seconds to exit the setup menu.

3.17 WIRELESS SETTING

• To set the wireless mode refer to the following guide:
• Press the MENU button until the display shows Wireless Setting, then press the ENTER button.
• Use the UP/DOWN button until the display reads Receive Setting, and then press the ENTER button and
select the ON mode.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.
NOTE - After you complete these steps, you have to synchronize with any wifi unit with which you want
to communicate by pressing the sync button present on the same. Then connect any DMX console to wifi
unit for to open the communication with the DISPLAYCOBTRWDWW unit.
• To reset the unit press the MENU button until the display shows Receive Reset, then press the ENTER
button.
• Use the UP/DOWN button until the display reads Yes, and then press the ENTER button.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.
diSpLAYcoBTRWdWW