Identifying Adapter Positions - IBM RT User's Setup Manual

Identifying Adapter Posi ti ons
Look at the adapter slots on the system diagram you unfolded
earlier. In the IBM 6150, notice that adapter slots 2, 4, 5, 7, and 8
have two tab slots, while adapter slots 3 and 6 have only one tab
slot. If an adapter has one tab, try to put it in adapter slot 3 or 6,
saving the positions with two slots for adapters with two tabs.
In the IBM 6151, notice that slots 2, 3, 4, and 5 have two tab slots,
while slot 1 has only one tab slot. If an adapter has only one tab,
try to put it in adapter slot 1, saving the slots with two tabs for
adapters with two tabs.
The following illustration shows the tab positions of the adapters
you can install in the system units. The adapters all have one of
the following basic forms:
Section 1. Getting Started
AJZIF217
1-15