Table of Contents
Advertisement
6.3 Configuring the two serial interfaces
The 2 output ports of the unit are identical.
Each port has the same functionality and may be connected to a PC or printer.
(configuration of print-out is achieved via the menu of the balance)
To set the parameters for the two interfaces, call the
relevant menu.
One of the following operating modes may be set for each interface.
rE CR, AU PC, AU Pr, Pr PC and bAPr.
For respective definitions please refer to the operating instructions of the balance.
You may also select a baud rate for each interface.
1200, 2400, 4800, 9600, 19200, 38400 baud.
Settings for interfaces:
The menu of interface 1 and the related steps to be taken are described below:
To set interface 2, use the Mode2 or Print2 key.
6.4 Display background illumination
To set the backlighting, use parameter bL
ON – backlighting turned on
OFF – backlighting turned off
CH – automatic cut-off of backlighting after 20 seconds.
Setting the backlighting
Press the Mode 1 key and keep it pressed down. Additionally
press the Print1 key and keep it pressed down until "Pr 1"
appears. Release both keys.
Press the Print1 key 2 x, "bL" appears.
Press the Mode1 key
The mode can be converted using the Print1 button
( Ch, on, off ).
The changed setting is taken over by pressing
the Mode1 button.
Display returns to display mode.
YKD-BA-e-0710
Balance display
Pr 1
bL
bL Ch
bL on
0.0 g
9
Advertisement
Table of Contents
