Williams Sound Digi-Wave DLT 400 User Manual page 12

Digi-Wave 400 Series
Example - Intercom
One DLT transceiver is set up as a Master 1 unit. All other DLT transceivers are programmed as a Guest unit. Up to six people
can have open microphones and be talking at the same time. When a 7th person desires to speak, they push their talk button.
This deactivates the talk button of the first Guest that turned their mic on. This First-In-First-Out order continues each time a
member pushes their Talk button who is not a part of the speaking group.
programmed as
Talk Mode: Push-to-Talk and Push-n-Latch (DLT Master 2 and Guest Only)
On a DLT transceiver, the Master 2 or Guest Talk Mode can be changed to Push and Latch or Push to Talk. Master 1 DLT
transceivers are always set to Push-N-Latch mode. This feature is not available on a DLR Receiver as it does not have a
microphone or talk button.
In Push-n-Latch mode, when the talk button is pressed and released, it stays in talk mode until the talk button is pressed and
released again.
In Push-to-Talk mode (the default mode), the talk button must be held down while speaking, and when released, it shuts off.
Tone Control
The default for tone control is 5, unless in Hearing Assistance mode, where the default is 9.
Using the up and down arrow buttons, adjust the tone up or down to your preference. The number range indicates:
• 1 = Most bass response
• 5 = Flat
• 9 = Most treble response
12
DLT 400
programmed
as Guest
DLT 400
Master 1
CH 1
DLT 400
programmed as
Guest
INTERCOM FEATURE
SUPPORTS UP TO SIX
SIMULTANEOUS TALKERS.
DLT 300
programmed
as Guest
DLT 400
programmed as
Guest
DLT 300
programmed as
Guest