Williams Sound PA R35 Instructions For Use & Care

Personal PA® R35 Receiver
Instructions For Use & Care
O I
PERATING NSTRUCTIONS
1. Install two (2) AA alkaline or NiMH rechargeable batteries. If you're using
rechargeable batteries, they must be charged before using.
2. Plug the earphone into the "EAR" jack on the top of the unit.
3. Turn the receiver on by rotating the volume control knob clockwise. The
receiver's ON indicator should illuminate green.
4. Adjust the volume for your comfort.
5. To turn the receiver off, rotate the volume control knob counter-clockwise
until it clicks off. The receivers' ON indicator should go dark.
Note: To maximize battery life, turn the receiver off when it's not in use.
E C
ARPAD LEANING
Do not immerse the earphone in water or other cleaning agent. Foam pads may
be removed and washed with a mild laundry soap solution, rinsed thoroughly,
and air-dried. Foam pads may also be replaced with new pads.
B I
ATTERY NFORMATION
Alkaline batteries (BAT 001):
Rechargeable NiMH batteries (BAT 026):
Batteries from other suppliers may provide different operating life.
NOTE: The ON indicator will illuminate RED to indicate a low battery.
I R
NSTALLING AND EPLACING
1. Open the battery compartment by lifting the tab on the back of the receiver
with a finger.
2. To remove depleted batteries, pull up on the fabric strip.
3. If Alkaline (non-rechargeable) batteries are being installed, slide the
FRM 452
80 hours
50 hours per charge
B
ATTERIES
®
Williams Sound
Helping People Hear