Table of Contents
Advertisement
ASSEMBLY
• To hire an authorized service technician to
assemble the treadmill, call 1-800-445-2480.
• Assembly requires two persons.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until you finish all assembly steps.
• After shipping, there may be an oily substance
on the exterior of the treadmill. This is normal. If
there is an oily substance on the treadmill, wipe
it off with a soft cloth and a mild, non-abrasive
cleaner.
1. Go to my.proform.com on your computer and
register your product.
• activates your warranty
• saves you time if you ever need to contact
Customer Care
• allows us to notify you of upgrades and offers
Note: If you do not have Internet access, call
Customer Care (see the front cover of this
manual) and register your product.
2. Make sure that the power cord is unplugged.
Remove and discard the two screws (A) and the
shipping bracket (B) on the right side of the Base
(74). Then, remove and discard the screws and
the shipping bracket (not shown) on the left side
of the Base.
Next, remove the tie (C) securing the Upright
Wire (63).
Then, press a Base Cap (70) into each side of
the Base (74).
• Left parts are marked "L" or "Left" and right parts
are marked "R" or "Right."
• To identify small parts, see page 7.
• Assembly requires the following tools:
the included hex key
one Phillips screwdriver
To avoid damaging parts, do not use power tools.
1
2
B
74
A
8
C
63
70
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Sport 4.0 and is the answer not in the manual?
Questions and answers
The treadmill has a sickening stinky smell when in use. Smells like something burning.
The Pro-Form Sport 4.0 treadmill may have a burning smell when in use due to excessive wear on the walking belt, improper lubrication, or unauthorized substances applied to the belt or walking platform. The manual advises against using silicone spray or other substances unless instructed by an authorized service representative, as these may deteriorate the belt and cause excessive wear. If the issue persists, checking the front cover of the manual for lubrication instructions or contacting an authorized service representative is recommended.
This answer is automatically generated
I tried the manual calibration due to the incline not working....However it is still only going up to level 1 n back down. It is not going any higher.
To fix the incline issue on your Pro-Form Sport 4.0 treadmill, follow these steps to recalibrate the incline system:
1. Insert the key into the console while holding down the Stop button.
2. Release the Stop button.
3. Press the Stop button again, then press the Incline increase or decrease button.
4. The treadmill will automatically rise to the maximum incline level and then return to the minimum level.
5. If the incline system does not start calibrating, press the Stop button again and then press the Incline increase or decrease button again.
6. Once calibration is complete, remove the key from the console.
This should reset the incline system and resolve the issue.
This answer is automatically generated
@Mr. Anderson It is not going anywhere further than level 1
Motor size and weight limit
The Pro-Form Sport 4.0 has a 2.5 HP motor and a maximum user weight limit of 110 kg (approximately 300 lbs).
This answer is automatically generated