Table of Contents
Advertisement
3. Identify the Right Upright (76). Have a sec-
ond person hold the Right Upright near the
Base (74).
See the inset drawing. Tie the wire tie (C) in
the Right Upright (76) securely around the end
of the Upright Wire (63). Then, insert the Upright
Wire into the lower end of the Right Upright as
you pull the other end of the wire tie through the
Right Upright.
4. Lay the Right Upright (76) near the Base (74).
Press the Upright Grommet (73) into the square
hole (D) in the Right Upright. Make sure not to
pinch the ground wire (E).
Next, remove and discard the indicated
screw (F).
Then, attach the ground wire (E) to the Right
Upright (76) with a #8 x 1/2" Ground Screw (1).
3
63
C
74
4
9
63
76
C
76
1
74
E
F
D
76
73
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Sport 4.0 and is the answer not in the manual?
Questions and answers
The treadmill has a sickening stinky smell when in use. Smells like something burning.
The Pro-Form Sport 4.0 treadmill may have a burning smell when in use due to excessive wear on the walking belt, improper lubrication, or unauthorized substances applied to the belt or walking platform. The manual advises against using silicone spray or other substances unless instructed by an authorized service representative, as these may deteriorate the belt and cause excessive wear. If the issue persists, checking the front cover of the manual for lubrication instructions or contacting an authorized service representative is recommended.
This answer is automatically generated
I tried the manual calibration due to the incline not working....However it is still only going up to level 1 n back down. It is not going any higher.
To fix the incline issue on your Pro-Form Sport 4.0 treadmill, follow these steps to recalibrate the incline system:
1. Insert the key into the console while holding down the Stop button.
2. Release the Stop button.
3. Press the Stop button again, then press the Incline increase or decrease button.
4. The treadmill will automatically rise to the maximum incline level and then return to the minimum level.
5. If the incline system does not start calibrating, press the Stop button again and then press the Incline increase or decrease button again.
6. Once calibration is complete, remove the key from the console.
This should reset the incline system and resolve the issue.
This answer is automatically generated
@Mr. Anderson It is not going anywhere further than level 1
Motor size and weight limit
The Pro-Form Sport 4.0 has a 2.5 HP motor and a maximum user weight limit of 110 kg (approximately 300 lbs).
This answer is automatically generated