Advertisement
Tools Required for the Installation
T-10 TORX driver - set to 9 in-lbs (1.02 N.m)
T-20 TORX driver - set to 21 in-lbs (2.38 N.m)
5/16-in (8 mm) nutsetter or open end torque wrench - set to 10 in-lbs (1.13 N.m)
5/16-in (8 mm) nutsetter or open end torque wrench - set to 21 in-lbs (2.38 N.m)
9 mm nutsetter or open end torque wrench - set to 21 in-lbs) (2.38 N.m)
1/4-in (6 mm) open end wrench
Use a 5/16-in torque wrench set to 10 in-lbs on all cable connections except the front and rear
CAUTION
panel bulkhead connectors. On these, use a 9 mm nutsetter or open end torque wrench set to
21 in-lb.
About Installing the Upgrade
Products affected . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .N5247A Option 400
Installation to be performed by . . . . . . . . . . . . . . . . . . . . . . . .Keysight service center or personnel qualified by
Estimated installation time . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 hours
Estimated adjustment time. . . . . . . . . . . . . . . . . . . . . . . . . . . .0.5 hour
Estimated full instrument calibration time . . . . . . . . . . . . . . .4.5 hours
6
Description
Keysight
Qty
Part Number
1
N/A
1
N/A
1
N/A
1
N/A
1
N/A
1
N/A
Installation Note N5247-90103
Advertisement
