Advertisement
Getting Prepared
Tools Required for the Installation
Description
T-6 TORX driver - set to 4 in-lbs (0.45 N.m)
T-8 TORX driver - set to 6 in-lbs (0.68 N.m)
T-10 TORX driver - set to 9 in-lbs (1.02 N.m)
T-20 TORX driver - set to 21 in-lbs (2.38 N.m)
5/16-in (8 mm) nutsetter or open end torque wrench- set to 10 in-lbs (1.13 N.m)
5/16-in (8 mm) nutsetter or open end torque wrench - set to 21 in-lbs (2.38 N.m)
3/16-in (5 mm) nutsetter or open end torque wrench - set to 6 in-lbs (0.68 N.m)
5/8-in (16 mm) nutsetter or open end torque wrench - set to 21 in-lbs (2.38 N.m)
9 mm nutsetter or open end torque wrench - set to 21 in-lbs (2.38 N.m)
1-in (25.4 mm) torque wrench - set to 72 in-lbs (8.15 N.m)
1/4-in (6 mm) open end wrench
Use a 5/16-in torque wrench set to 10 in-lbs on all cable connections
except the bias tees and the front and rear panel bulkhead connectors. On
the bias tees use a 5/16-in torque wrench set to 9 in-lbs. On these, use a
9 mm nutsetter or open end torque wrench set to 21 in-lb.
About Installing the Upgrade
Products affected
Installation to be performed by
Estimated installation time
Estimated adjustment time
Estimated full instrument calibration time
10
Qty
1
1
1
1
1
1
1
1
1
1
1
N5244B and N5245B Option 224
Keysight service center or personnel qualified
by Keysight
5 hours
2 hours
4.5 hours
Installation Note N5245-90117
Part Number
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
Advertisement
