Advertisement
Step 19.
Install the Braces
Refer to
Figure 15
for this step of the procedure. New parts are listed in
Figure 15
Brace Installation
Step 20.
Reinstall Front Panel Assembly
For instructions on reinstalling the front panel assembly, click the Chapter 7 bookmark "Removing and
Replacing the Front Panel Assembly" in the PDF Service Guide
Step 21.
Position the Cables and Wires to Prevent Pinching
On the top side of the PNA, carefully position the grey flex cables so they can't be pinched between the covers
and the rails.
On the bottom side of the PNA, carefully fold or push down the ribbon cables and wires so they can't be pinched
between the hardware and the outer cover. Ribbon cables and wires must never be positioned on top of
hardware.
30
Table 1 on page
1
.
Installation Note N5247-90103
7.
Advertisement
