Table of Contents
Advertisement
3.3
Inserting batteries
1.
Remove the rubber protection
cover. To do so, hold the rubber
protection cover at the upper side
and pull it over (figure
case of a sensor being connected,
disconnect it beforehand and if
your device is provided with an
optional USB port, remove the protection cap of the USB
socket beforehand too.
2.
Take hold of the device with one hand, press your thumb
onto the engraved area of the battery compartment (1)
and drag downwards (2) (figure 3).
3.
Insert the batteries with negative and positive terminals
matching those indicated on the battery compartment.
Press down the batteries so that they lay flat on the bot-
tom of the housing (figure 4).
»
As soon as all batteries have been inserted, the device
switches on automatically.
4.
Push the battery cover onto the housing until it clicks into
place (figure 5). Then mount the rubber protection cover
onto the housing, beginning at the end where the battery
compartment is situated.
4.
Using the device - Basics
4.1
Switching on the device
• Press the
»
The display will then show the status indicator (figure
status").
»
After inserting the batteries, the device switches on automatically.
Page | 16
1
and 2). In
button for 3 seconds.
1
"9. Checking the device's
2
3
4
5
Advertisement
Table of Contents
