Table of Contents
Advertisement
6.5
Viewing individual readings from a series of measurements
To do so:
You must have saved a series of measurements
(e.g. 2 logs). The display will now appear as shown in
figure 31.
1.
Press
.
2.
Navigate to the required measurement series. To
do so, press
»
The display will now appear as shown in figure 32.
3.
Press
to switch to another input level.
»
The display will now appear as shown in figure 33.
4.
Press
»
The display will now appear as shown in figure 34.
5.
Navigate to the required reading (No.: 1, No.: 2, No.:
3). To do so, press
6.
Press
to leave this screen.
6.6
Deleting all measured values (data log)
To do so:
You must have taken and saved one or several
readings.
1.
Press
twice or hold for 2 seconds.
2.
Select Edit Logs (figure 35). To do so, press
and confirm by pressing
3.
Select Clear Logs (figure 36). To do so, press
and confirm by pressing
4.
The display will then show the message clear?
(figure 37).
5.
Confirm by pressing
»
The data log has been deleted.
Page | 28
or
.
again.
.
.
or
.
or
.
31
32
33
34
35
36
37
Advertisement
Table of Contents
