Installation Instructions - nvent Raychem HAK-C-100 Installation Instructions Manual

FM REQUIRED DIVISION 1 INSTALLATION RECORD
To complete the FM approval process, fill out this form and return it to the nVent Customer Service Center
(fax number (650) 361-6711).
Company Name
Circuit ID No.
AREA:
Auto-ignition temperature (AIT)
Group classification
HEATER CIRCUIT:
Heating cable type
Supply voltage
Circuit length
Maximum pipe temperature
Heat temp. identification number (T-rating)
COMPONENTS:
Power connection
End seal
Tee connection
Spice

INSTALLATION INSTRUCTIONS:

Correct components per manufacturer's specification
Seal fittings opened and inspected (properly poured)
Ground-leakage device tested
INSULATION RESISTANCE TESTING:
Minimum insulation resistance must be 1000mΩ.Iflessthan1000mΩseeTroubleshootingGuide(pages12 and 13).
Heating Cable Test 1 (refer to Step 16a and b of HAK-C-100 installation instructions)
Instrument used:
Measured before thermal insulation is installed:
Date:
Date:
Post-Thermal-Insulation Heating Cable Test 2 (refer to Steps 21 and 16b of HAK-C-100 installation instructions)
Instrument used:
Measured after thermal insulation is installed:
Date:
Date:
Circuit Ready to Commission
Prepared by
Approved by
InsulationResistanceTestA(Ω)
InsulationResistanceTestB(Ω)
InsulationResistanceTestA(Ω)
InsulationResistanceTestB(Ω)
Purchase Order No.
Initials
GROUND-FAULT EQUIPMENT
Make and model
Ground-fault equipment protection
device trip level (mA)
INSTALLATION INSTRUCTIONS:
Correct components per manufacturer's
specification
Seal fittings opened and inspected
(properly poured)
Ground-leakage device tested
GROUND-FAULT EQUIPMENT PROTECTION:
Make and model
Ground-fault equipment protection device trip level (mA)
500 Vdc
500 Vdc
Company
Company
Reference
Drawing(s)
Test Value/
Remarks Date
Protection:
Calibration due date:
1000 Vdc 2500 Vdc
Calibration due date:
1000 Vdc 2500 Vdc
Date
Date
nVent.com | 15