Appendix 3 Notification Messages - Furuno FELCOM251 Operator's Manual

APPENDIX 3 NOTIFICATION MESSAGES

SIM errors/events appear in the IP Handset and in the Web interface of the Communication Unit.
The list below shows the notification messages that may appear.
Notification priority level is annotated in the "Lvl" column as follows:
Warning: "W"; Error: "E"; Info: "I"; no priority: "-"
Code Lvl BDU/Web UI Message Handset Message
0x2000001A Under processing.
0x2F0000FE W Configuration failed.
0x1400 W No satellite signal.
0x2000 I Weak satellite signal.
0x804C W The selected satellite is
not available at the
current position.
0x8059 W Unable to point on
satellite because;
- satellite is under
horizon or;
- Antenna blockage or;
- Antenna HW is
malfunction;
- Too high vibration.
0x1600 W Rescue calls only.
0x1700 W Registration for voice
service failed.
0x1800 W Registration for data
service failed.
0x8049 W Data transfer speed
reduced due to high
temperature.
0x10204 W Data transfer speed
reduced due to high
temperature and all
streaming connections
closed.
0x10205 W All data connections
are closed due to high
temperature.
0x802F E Antenna start up failed. Antenna start-up
0x8030 E Antenna start up failed. Antenna start-up
0x8031 E Antenna start up failed. Antenna start-up
AP-8
The Comm. Unit is The Comm. Unit is
under processing. under processing. Try again later.
Configuration Configuration failed. Restart the
failed. Communication Unit and try again.
NA The FELCOM system no longer receives a
signal from the satellite.
NA The signal from the satellite is weak.
The satellite is not The terminal is set up to use a satellite that is
visible from here. not visible at the current GPS position.
Unable to point on Unable to point on satellite because;
satellite. - satellite is under horizon or;
- Antenna blockage or;
- Antenna HW is malfunction;
- Too high vibration. Make sure Antenna is not
blocked and vibrations is within the specified
limit. Then restart the Communication Unit. If
the problem persists, contact your dealer.
Rescue calls only. The SIM card is not accepted by the network.
Only emergency calls are allowed.
Registration for Registration for voice service failed. If the
voice service problem persists, contact your SIM provider.
failed.
Registration for Registration for data service failed. If the
data service problem persists, contact your SIM provider.
failed.
Data speed reduced The bit rate of the data channel is reduced
due to high because the temperature is too high.
temperature.
Data communication Data transfer speed reduced due to high
is limited due to temperature and all streaming connections
high temp. closed. Move the Communication Unit to a
cooler place.
Data communication All data connections are closed due to high
is not available temperature. Move the Communication Unit to
due to high temp. a cooler place.
Antenna main image could not be loaded
failed.
Antenna could not enter main application
failed. mode
Failed to enter normal operation
failed.
Explanation/Remedy