Mounting Accessories - Yale HSA6600 Installation Manual

4

Mounting Accessories

Mounting the Hub
The Hub can be free standing, either vertically or
horizontally on a flat surface with access to mains socket
and broadband internet router.
It is also suitable for wall mounting. Using the two holes on
the mounting back plate, mark the position of the holes.
Drill two holes and fix with the screws and plugs provided.
Hook the Hub onto the plate.
Check Accessories Range
Find a location where the device is to be mounted, see
section "Location Planning" for suggestions.
Before proceeding to mount the devices physically, check
that the Hub will receive the system radio transmissions by
doing a simple radio range test.
Go to the app menu, select Settings > Alarm Settings >
Test then select "Walk Test".
Hold the accessories in the desired location and press the
Test/Learn button (see below) on the accessories.
• KEY PAD: Press button 8 + 9 together for 1 second.
• ALL OTHER accessories. Hold the accessories in the
desired location and press the test button for 1 second
If the sensor signal reached the Hub, it will show up on the
app screen.
When you are happy that all your accessories can
communicate with the Hub, please proceed to mounting
the accessories.
Note: Siren does not have a range test and will not appear
in the app device list. To test, arm/disarm the system. If the
siren beeps/flashes, a signal is being received successfully.
8
Mounting other devices
Find a location where the device is to be mounted,
see section "Location Planning" for suggestions.
PIR Motion Detector
i
Before proceeding to mount the devices
1. Open the PIR by loosening the bottom screw. Knock
physically, check that the control unit will
out the relevant holes on the base where the plastic is
receive the system radio transmissions by
thinner. The center 2 knockout holes are for flat wall
doing a simple radio range test.
mounting while the 4 side holes are for corner mounting.
2. Drill holes into the wall using the knockout holes on the • Put the control unit into walk test mode.
base as a template.
• KEYPAD: press the arm button.
• HELP BUTTON: press the button.
• ALL OTHER DEVICES: Hold the device
in the desired location and press the
learn/test button, the control unit should
respond with a chime.
Wall fixing
• When you are satisfied that the devices
knockouts X 2
work in your chosen locations, proceed
with the installation as described.
knockouts X 4
• If the control unit does not respond,
3. Fit wall plugs and secure the PIR base with the screws
the location may be out of range, try
provided.
alternative locations until reliable radio
contact is obtained.
4. Fit the PIR back together and tighten bottom screw, the
PIR installation is complete.
Mounting the Key Pad
Mounting the Keypad:
Fixing Slots X 2
Keypad
Cradle Open
1. Knock out the fixing holes. Drill holes into the wall using
1 Drill holes into the wall using the fixing slots as a
the fixing holes as a template.
template.
2 Fit wall plugs into the wall and fix cradle with the 2. Fit wall plugs into the wall and fix back cover with the
screws provided. Fix front of the Key Pad onto the
screws provided.
10
back plate.
Corner fixing
3 Slide the
4 Close th
Mounting
1 Open th
Knock o
the plas
holes ar
holes ar
2 Drill hole
the base
3 Fit wall p
screws p
4 Fit the P
screw, the
i
The
bat
of t
'rea
rep
rep
Any
rep
furt