Yale HSA6600 Installation Manual page 18

9
Troubleshooting
PIR Motion Detector LED flashes
• Batteries are low or the tamper switch is disturbed. Check
that the tamper switch spring is making contact with base.
If the tamper switch is OK, change batteries with new AA
alkaline replacements (see page 15).
PIR Motion Detector does not respond to
movement
• Batteries are completely exhausted. Change the batteries
with new AA alkaline replacements (see page 15)
Hub LED
Top LED solid Green = Linked to the Server/Internet
Top LED not lit up = No link to the Server/Internet
Top LED flashing = Hub in learn mode
Middle LED solid Yellow = System has Fault. Further detail will
be found in the Yale App
Middle LED not lit = OK
Bottom LED solid red = System Armed
Bottom LED flashing red = System Part Armed
Bottom LED not lit up = System Disarmed
Consumer Support Helpline
Should you have any questions or experience a problem with
your Alarm Kit, please visit Yale.co.uk/help.
18
(cont.)