Cutting Blades - pellenc RASION 2 EASY User Manual

6.2.1. CUTTING BLADES

The cutting blades ensure the grass is cut cleanly. A high quality mower blade cuts the grass cleanly without ripping or
shredding. Any bent, worn or perforated blades must be changed.
These parts must be replaced as a precautionary measure
or at least once a year:
1. Rasion blade cleaning kit, collection, ref.: 131404 (se-
ries)
OR
2. Rasion blade maintenance kit, universal, ref.: 134104
Important
For your safety, the blades and retaining pins must be
checked immediately after an impact.
Tip the lawn mower upright. If the cutting blades are not per-
pendicular to each other, it may be because the retaining
pins are broken.
In this case the mower must not be used to cut grass and the
retaining pins must be replaced before the next use.
Before changing the retaining pins, check the state of wear
of the cutting blades that can be replaced at the same time.
In case of excessive vibration, replace the blades:
• Unscrew and remove in order the 19mm nut, the Belleville
washer and the cutting blade.
• Replace old pins with new pins if necessary.
• Sharpen the blade with a smooth-cut file following the
bezel, filing only in one direction, from the inside to the out-
side of the blade, in one or two movements.
• Check that the blade is well balanced.
• Refit the blade in the direction of assembly, with tightening
torque of 35 Nm
Caution
Always disconnect the lawn mower from the battery before working on the cutting blades.
LAWN MOWER RASION 2 EASY
59_141654-A
59N_18_064
59N_18_072
59N_18_073
33