Safety Rules; General Notes On Safety And For The User; Conditions Of Installation And Normal Operation - FPZ SCL TS Series Instructions Manual

2

SAFETY RULES

2.1

GENERAL NOTES ON SAFETY AND FOR THE USER

The instructions listed below must be read carefully and become a fundamental part of daily
procedures in the use and maintenance of all the equipment, in order to prevent any kind of
accident, injury or damage.
•
Do not start the unit until its operation is clearly understood.
•
If any doubts arise, despite having read this manual carefully and completely, contact FPZ S.p.A.
•
Make sure all personnel involved in the use of the unit are informed regarding the safety requirements.
•
Before starting the unit, the operator must check the efficiency of the safety devices and for any obvious defects in the unit. In case
of any defects, immediately notify FPZ S.p.A.
•
Check the proper operation of all the safety devices every day.
•
The safety devices must never be removed or disabled.
•
During maintenance or repair work it may be necessary to exclude some safety devices from the service. This operation must be
carried out by authorised personnel.
•
Never attempt rash solutions.
•
All installation, commissioning and maintenance operations must be carried out exclusively by qualified personnel.
•
Do not modify the electrical connections on the unit.
•
Do not wear clothes, jewellery or accessories that can get caught in moving parts.
•
Always keep the area around the unit free of obstructions.
•
Use appropriate PPE such as boots, gloves, goggles and work clothes.
•
Pay attention to all danger and caution signs placed on the unit.
•
Always apply and enforce the safety rules; in case of any doubts, always consult this manual before acting.
•
The unit must be used only and exclusively for its intended purpose and in accordance with that contractually established with FPZ
S.p.A.
Non-compliance with the unit's intended use can cause serious accidents
The unit must only be started:
•
In conformity with the purposes of use, transport and handling specified in "FORESEEN USE",
•
respecting the values given in the "SPECIFICATIONS" and RATING DATA.
2.2

CONDITIONS OF INSTALLATION AND NORMAL OPERATION

Startup and operation must occur only under the following conditions:
•
The unit must be completely assembled and intact, i.e. not damaged or tampered with.
•
The silencer must be properly connected to the system piping.
•
The machine must be securely fixed in place.
•
The motor must be connected to a suitable control panel.
•
If installed outdoors, protect the unit against the sun and weather.
Risk of injury due to shearing, crushing, entanglement!
During work on the unit there are risks of injury due to shearing, crushing or entanglement!
Therefore it must be carried out by technicians who handle and install the machine, taking the necessary safety measures and
following the instructions given in this manual.
Danger due to escaping process fluids!
Danger due to overpressure with sudden release of process fluids (injury to the skin and eyes)!
Start the machine only if properly connected.
Danger due to electricity!
Improper behaviour can cause serious accidents!
Work on the electrical equipment must only be carried out by qualified and authorised electricians!
Before starting work on the unit or system, take the following precautions:
- disconnect the mains power;
- open the terminal box only after making sure the power is disconnected;
- take steps to prevent the power from being reconnected.
FPZ-MI-K TS-MOR-USA-15-R03 12 / 79