Programming Help For Lokmaus 2 / R3 - Multimaus - roco MultiMAUS Manual

Programming Help for Lokmaus 2 / R3 – multiMAUS
Previous operating manuals for digital ROCO articles (e.g. 42624 turnout drive) only describe the standard
programming mode for Lokmaus 2 / R3. The following includes a table which compares the programming
procedure for the Lokmaus 2 / R3 and quick programming (see page 45) on the multiMAUS.
For more information see the operating manual for the Lokmaus 2 / R3. To program CV29 see the operating
instructions included with the decoder.
CV
1 – Address
2 – Minimum speed
3 – Start-up delay
4 – Braking delay
5 – Maximum speed
29 – Decoder settings
Change speed steps
8051281925.indd 61
multiMAUS
+
+
+
+
+
Can only be programmed in
menu mode (see page 52)
+
/
Lokmaus 2 / R3
(for comparison)
+
+
+
+
+
+
+
/
10.05.2016 12:52:19
61