The Menu Functions Of The Multimaus - roco MultiMAUS Manual

The menu functions of the multiMAUS

The multiMAUS has three main menus with which you can both perform comprehensive programming
and change the basic settings of the multiMAUS. This menu levels can be accessed using two simple key
combinations:
Press the "MENU" key on its own for approximately 5 seconds (the duration can be set in the "SET-
▪
TINGS" menu), practically single-handed operation of the multiMAUS,
Press the shift and "MENU" key together.
▪
A locomotive cannot be controlled whilst the multiMAUS is in menu mode. Internal communication with
another multiMAUS or other DCC devices is however assured.
or
MENU
A scrolling text program which is integrated in the multiMAUS displays all the menu names with more
than 5 letters as scrolling text. In the display figures in this manual the abbreviated menu name is shown.
The complete name is shown directly underneath the figure.
You use one of the "arrow keys" to continue in the menu level. You use the "light / OK" key to call up the
respective submenu. The menus are all numbered. The numbers are shown at the bottom of the display.
Each of the three large main menus has its own pictograms for clear identification. They appear in addition
to the word "MENU". You will also find them in the respective submenus:
Menu 1 "ENGINE": Symbol "
▪
Menu 2 "PROGRAMMING": Lettering "Prog",
▪
Menu 3 "SETTINGS": Symbol "
▪
There are two ways to exit the menu level:
Press the "STOP" key. You may need to do this several times depending on the submenu which you are
▪
currently in. Each time you press "STOP" you go back one level.
Press the "MENU" key (alone or together with the shift key) to exit all levels immediately and return
▪
to locomotive and turnout mode.
All of the menus of the multiMAUS can be found in the large overview on the next two pages.
8051281925.indd 47
Section 2 The Menus
▪
MENU
PROGRAM
",
".
+
MENU
or
Hold for appr. 5 seconds
SETTINGS
47
10.05.2016 12:52:17