Polaris Slingshot SL 2020 Owner's Manual page 33

TOGGLE BUTTONS
Press and release either toggle button
Area 2 modes. Press and hold either toggle button to reset an item. See the
Gauge Settings Menu section for details.
With the ignition off, pressing the MODE button or either toggle button will
power up the Rider Information Center for 10 seconds to allow viewing of the
INDICATOR LAMPS
LAMP INDICATES
Cruise Control
Enabled
Cruise Control
Engaged
Anti-Lock
Brake System
High Beam
Turn Signal /
Hazard
Signals
Low Fuel
Hot Engine
Check Engine
FEATURES AND CONTROLS
t
to cycle through the options menu or
TIP
odometer and the clock.
CONDITION
Before using the cruise control, read the safety and
operation procedures. See page 28.
Before using the cruise control, read the safety and
operation procedures. See page 88.
Your dealer can assist if this lamp remains on. When the
lamp is illuminated, the anti-lock brakes will not activate,
but the conventional brake system will continue to operate
normally.
This lamp illuminates when the headlamp switch is set to
high beam.
The turn signals are located at the top center of the
instrument cluster. Arrows flash when either a turn signal or
the hazard signal is activated. If a lamp fails, or if there is a
short circuit in the signal system, the lamp flashes at more
than twice the normal rate.
This lamp illuminates when approximately one gallon (3.8
liters) of fuel remains in the fuel tank.
This lamp illuminates to indicate an overheated engine. If
the indicator flashes, the overheating condition remains,
and the system will automatically reduce engine power.
If this lamp illuminates while the engine is running, promptly
contact an authorized dealer or another qualified person
who can assist with diagnosis. If abnormal engine
operation is detected the light will remain on as long as the
31