Polaris Slingshot SL 2020 Owner's Manual page 131

HEADLAMP BULB REPLACEMENT (CANADA)
When servicing a halogen lamp (bulb), avoid touching the lamp with bare
fingers. Oil from your skin leaves a residue, causing a hot spot that will shorten
the life of the lamp. If fingers do touch a lamp, clean it with denatured alcohol.
1. Pull the sealing boot away from the back of the bulbs and housing.
2. Press the looped end of the wire bulb retainer clip and swing the end toward
the center of the bulb to release it from the latch tab.
3. With the wire connector attached, pull the bulb out.
4. Disconnect the wire harness. Install the new bulb and secure the retainer.
5. Reinstall the sealing boot. Make sure it seals tightly around the bulb base
and lens to seal off from moisture.
HEADLAMP AIM ADJUSTMENT (CANADA)
1. Verify that headlamp aim inspection conditions are met. See page 127.
2. Position the vehicle on a level surface with the nose approximately 9 ft. (2.7
m) from a wall
3. Press the Engine Start button twice to enter Accessory Mode, then pull the
turn signal lever rearward (as if to activate the high beams).
If the engine was last powered-off with the high beams still on, then pulling the
turn signal lever in Accessory Mode will reactivate the high beams. Verify that
the LOW BEAM lights (not high beams) are activated to perform headlamp aim
4. Observe the headlight beam display on the wall. The beam displays at two
levels, higher at the right side and lower at the left side.
5. Measure from the floor to the lower beam display at the left side. When the
beam is properly adjusted, this measurement should be:
q
.
IMPORTANT
adjustment.
MAINTENANCE
129