Polaris Slingshot SL 2020 Owner's Manual page 109

ANGLE DRIVE FLUID
This fluid level does not require routine inspection. If you suspect a fluid leak,
inspect the fluid level.
Always change the angle drive fluid at the intervals outlined in the Periodic
Maintenance Chart section. Always use SLINGSHOT Angle Drive Fluid or
another Fully Synthetic 80W-90 fluid for the angle drive. See the Recommended
Service Products chapter for the part numbers of recommended service
products.
The fill plug is located on the left side of the angle drive housing. The drain plug
is located on the bottom of the housing, driver's side.
FLUID LEVEL CHECK
1. Elevate the vehicle using appropriate jack stands. Make sure the elevated
vehicle is level.
2. Remove the fill plug
hole, add the recommended fluid to bring the level to the bottom edge of the
fill hole.
Use a syringe to add the fluid. If a syringe is not available, use a funnel and
3. Reinstall the fill plug.
q
. If the fluid level is not at the bottom edge of the fill
NOTICE
tube to add the fluid.
TORQUE
10-14 ft-lbs (14-19 Nm)
MAINTENANCE
107