Polaris Slingshot SL 2020 Owner's Manual page 139

14. Elevate the vehicle using appropriate jack stands. Remove the wheels to
prevent flat spots on the tires.
15. Do not engage the park brake. If engaged, the brake pads may stick to the
discs.
16. Cover the vehicle with a fabric cover. Do not use plastic or vinyl covers,
which trap moisture and encourage rust and corrosion.
BATTERY STORAGE
1. Have the battery removed by an authorized dealer.
2. Clean the battery terminals first with a wire brush to remove any loose
deposits.
3. Wash the posts and the ends of the battery cables with a solution of one part
baking soda to 16 parts water. Rinse with clean water and wipe dry.
4. Apply a thin film of dielectric grease to the posts and cable connectors.
5. Clean the outside of the battery with a solution of mild detergent and warm
water.
6. Store the battery in a dry area with a temperature of 32° to 90° F (0° to 32°
C).
7. While in storage, fully charge the battery once a month.
REMOVAL FROM STORAGE
1. Remove the fabric cover.
2. Remove intake and exhaust opening covers (if covered for storage).
3. Install the tires. Lower the vehicle and remove the jack stands.
4. Verify that tire pressure is at specification. Refer to safety labels on the
vehicle or to the Specifications chapter.
5. Install the battery and perform an electrical inspection.
6. Inspect the spark plugs. Install new spark plugs if necessary.
7. If the vehicle was stored in an area subject to wide swings in temperature
and humidity (such as outdoors), change the engine oil before starting the
engine.
During storage, temperature and humidity changes can cause condensation to
form in the crankcase and mix with engine oil. Running the engine with oil that
contains condensation can cause engine damage.
CLEANING AND STORAGE
NOTICE
137