Polaris Slingshot SL 2020 Owner's Manual page 130

MAINTENANCE
CENTER HEADLAMP AIM ADJUSTMENT
1. Verify that headlamp aim inspection conditions are met.
2. Position the vehicle on a level surface with the nose approximately 9 ft. (2.7
q
m) from a wall.
3. Press the Engine Start button twice to enter Accessory Mode, then pull the
turn signal lever rearward (as if to activate the high beams).
If the engine was last powered-off with the high beams still on, then pulling the
turn signal lever in Accessory Mode will reactivate the high beams. Verify that
the LOW BEAM lights (not high beams) are activated to perform headlamp aim
4. Observe the headlamp beam display on the wall. The beam displays at two
levels – higher on the right side and lower on the left side. When the beam is
properly adjusted, this measurement from the ground to the lower level beam
cutoff should be:
• 22.5" (57 cm)
5. To adjust a headlight beam, open the hood and turn the two upper headlamp
adjustment screws simultaneously and equally. Turning the adjustment
screws in tandem keeps the beam pointed straight, so as not to skew left or
right.
• Clockwise adjustment raises the beam
• Counter-clockwise adjustment lowers the beam
128
IMPORTANT
adjustment.