Mounting To Linear Actuator - Siemens SIPART PS2 6DR5 Series Compact Operating Instructions

Installing/mounting
3.4 Installing option modules
3.2

Mounting to linear actuator

For linear actuators, use the "linear actuator" mounting kit 6DR4004-8V or the integrated
attachment.
You require different installation parts depending on the selected actuator type. The mounting
kit is suitable for a stroke of 3 to 35 mm. For a larger stroke range, you require a separately
ordered lever 6DR4004-8L. Refer to the detailed operating instructions for further information
on mounting.
3.3 Mounting to part-turn actuator
You require an actuator-specific VDI/VDE 3845 mount to install the positioner on a part-turn
actuator. You receive the mount and screws from the actuator manufacturer. Ensure that the
mount has a sheet metal thickness of > 4 mm and reinforcements. You also need the mounting
kit 6DR4004-8D or the stainless steel coupling TGX: 16300-1556. Refer to the detailed
operating instructions for further information on mounting.
3.4 Installing option modules
Depending on the version of the positioner, the following option modules are available:
● Digital I/O Module (DIO) 6DR4004-6A / -8A
● Analog Input Module (AIM) 6DR4004-6F / -8F
● Inductive Limit Switches (ILS) 6DR4004-6G / -8G
● Analog Output Module (AOM) 6DR4004-6J / -8J
● Mechanic Limit Switches (MLS) 6DR4004-6K / -8K
● Internal NCS module 6DR4004-5L / -5LE
● NCS sensor 6DR4004-6N / -8N
For additional information and the corresponding safety notes to be observed when installing
the option modules, refer to the detailed operating instructions for your respective device
version.
3.4.1 Internal NCS module
The internal NCS module is used for wear-free position detection and is an optional equipment
version in the positioner. The internal NCS module is installed as an alternative to the Analog
Output Module (AOM) at the same slot in the positioner.
20
Compact Operating Instructions, 09/2019, A5E03436620-AE
SIPART PS2 (6DR5...)