Option Device Version M12 Connector - Siemens SIPART PS2 6DR5 Series Compact Operating Instructions

Procedure
1. Loosen the screw
2. Pull the transparent cover
3. Tighten every cable in the corresponding terminal.
4. Slide the transparent cover
5. Tighten the screw
6. Connect the cables of each switch to the lug of the printed circuit board in pairs. Use the
provided cable ties
Figure 4-11
4.2.6

Option device version M12 connector

This section describes which terminal of the devices and option modules listed below is
connected with the respective pole of the M12 connector.
Note
Technical specifications
Observe the specifications for the electrical data in the certificate and/or in section "Technical
data (Page 57)".
SIPART PS2 (6DR5...)
Compact Operating Instructions, 09/2019, A5E03436620-AE
①
on the transparent cover
①
of the transparent cover
③
for this purpose.
①
Screw
②
Cover
③
Cable tie
Connecting the cables
②
②
up to the front end stop.
②
up to the end stop of the basic electronics.
②
.
4.2 Electrical connection
.
Connecting
33