Siemens SIPART PS2 6DR5 Series Compact Operating Instructions page 51

Electropneumatic positioners

Hide thumbs Also See for SIPART PS2 6DR5 Series:

Initializing the part-turn actuator automatically

Note

Interrupting initialization

An ongoing initialization can be interrupted at any time. To do this, press

configured until then are retained.

All parameters are reset to factory settings only if you have explicitly activated the preset

settings in the "PRST" parameter.

1. Switch to the "Configuration" mode. To do this, press the

until the display shows the following:

2. Use the

the following:

3. Call the "2.YAGL" parameter. To do this, briefly press the

already been set to 90° automatically. The display shows the following:

4. Call the "4.INITA" parameter. To do this, briefly press the

following:

SIPART PS2 (6DR5...)

Compact Operating Instructions, 09/2019, A5E03436620-AE

button to change from linear actuator to part-turn actuator until the display shows

Commissioning

5.7 Commissioning part-turn actuators

. The settings

button for at least 5 seconds

button. This parameter has

button. The display shows the

Table of Contents

Show Quick Links