Mahindra Genio DC BS-III Diagnostic Manual page 8

Diagnostic Manual (EMS)
Genio DC BS-III & BS-IV
The following are the fonts of the alphanumeric characters of the IQA/IMA code, as
etched on the injectors.
EMS ECU Programming/Flashing
The EMS ECU required to be flashed in the following conditions –
BLANK ECU
1. Procure blank EMS ECU from spare part dept.
1805AAA01571N ECU WITHOUT ETK EDC17C55*
*
Check for the correct/latest part no in parts catalogue/Technical Service
Bulletins.
2. Flash the EMS ECU dataset with a latest dataset as per TSB or at the advice of
TEKline.
REFLASHING AN EXISTING ECU
1. Flash the EMS ECU with the correct/latest dataset. The matrix of the vehicles and
the related latest dataset will be released through TSB - if in doubt ask the TEKline.
2. Wrong dataset flashing may result in vehicle not starting and can lead to ECU
failure.
Software
ECU Type
Version
V32 EDC17C55
V32 EDC17C55
V32 EDC17C55
V32 EDC17C55
All copyrights reserved by
The repair methods given by the manufacturer in this document are based on the technical specifications, current at the time of release. The methods may be modified as a result of changes
introduced by the manufacturer in the production of the various component units and accessories from which the vehicles are manufactured. The reproduction, translation, transmission, in part of or
whole of the present document, are prohibited without the prior written consent of Mahindra & Mahindra Ltd.
at the Authorized Service Centre of Mahindra & Mahindra Ltd., will amount to unauthorized use and shall be liable for penalty/prosecution© 2010 Mahindra &
Mahindra Ltd.
Dataset ID Type
Factory/
1037513404
Reflashing
Factory/
1037513412
Reflashing
Factory/
1037513357
Reflashing
Factory/
1037513392
Reflashing
The use of this document by any person other than the trained personnel,
MAN-00139-8
August 2011/Rev 1
Model
GENIO BS III (Non AC)
GENIO BS IV (Non AC)
GENIO BS III (With AC)
GENIO BS IV (With AC)