Mahindra Genio DC BS-III Diagnostic Manual page 14

Diagnostic Manual (EMS)
Genio DC BS-III & BS-IV
List of DTC codes
Group
Fuel
Temperature
Sensor
Coolant
temperature
sensor
Rail Pressure
Sensor
Environment
Pressure Sensor
Air flow
Air temperature
Crankshaft
speed Sensor (
ISS)
Camshaft speed
signal
Off set between
crank & cam
signal
Vehicle speed
sensor
Clutch switch
All copyrights reserved by
The repair methods given by the manufacturer in this document are based on the technical specifications, current at the time of release. The methods may be modified as a result of changes
introduced by the manufacturer in the production of the various component units and accessories from which the vehicles are manufactured. The reproduction, translation, transmission, in part of or
whole of the present document, are prohibited without the prior written consent of Mahindra & Mahindra Ltd.
at the Authorized Service Centre of Mahindra & Mahindra Ltd., will amount to unauthorized use and shall be liable for penalty/prosecution© 2010 Mahindra &
Mahindra Ltd.
Code
P 0182 Voltage below lower limit.
P 0183 Voltage above upper limit.
P 0117 Voltage below lower limit.
P 0118 Voltage above upper limit
Minimum Temperature not reached within
P 2558
Minimum temperature or temperature raise
P 1126
no reached within time limit.
P 0193 Signal above the maximum limit.
P 0192 Signal below the minimum limit.
P 1190
Rail pressure offset – above Max limit
P 1191 Rail pressure offset – below Min limit.
P 169F Rail Pressure Sensor gradient monitoring.
P 0108
P 0107 SRC below Minimum limit
P 0103 Voltage above upper limit
P 0102 Voltage below Minimum limit
P 110B
Correction factor 0 monitoring of the drift
P 1109
compensation function of AFS
Correction factor 1 monitoring of the drift
P 010A
compensation function of AFS
Plausibility check of offset drift of
P 1103
airmass,ratio is lower than threshold low
Plausibility check of offset drift of
P 1104
airmass,ratio is higher than threshold high
P 0113 Voltage above upper limit
P 0112 Voltage below Minimum limit
P 0336
P 0335
P 0340
P 0341
P 1340 Offset between camshaft & crankshaft
P 0503 Exceeding of the maximum vehicle speed
Vehicle speed not plausible with fuel injected
P 0501
P 0704 Clutch switch is not plausible
August 2011/Rev 1
Label
time limit.
SRC above Max limit.
Signal error of AFS
Error in signal
No Signal
No camshaft signal
Wrong camshaft signal
and engine speed.
The use of this document by any person other than the trained personnel,
MAN-00139-14
Page
No
19
21
23
25
27
28
29
30
31
34
35
38
40
42
44
46
48