Toshiba Stratagy IVP8 Installation Manual page 6

4
PDKU/BDKU cards must be installed and programmed for a DSS Console.
❐
Install and program the PDKU/BDKU in the Strata CTX.
❐
Refer to the Strata CTX Programming Manual for DSS programming.
❐
Set the dss_active parameter to TRUE.
❐
Configure the DSS Port field on the User Menu – Options screen for each mailbox.
5
SMDI is required for the Call Record feature with Stratagy Release 3.3/IVP8. A BSIS card must be located
close to the Stratagy.
❐
Install and program serial card BSIS in the Strata CTX. Refer to the Strata CTX Programming Manual.
❐
A serial cable must be installed between the BSIS card and the Stratagy. Toshiba's PPTC-9 (with six-
conductor line-cord) is recommended.
❐
Stratagy's serial Port 1 is reserved for SMDI communication.
6
SMDI is required if the Stratagy is going to be synched with the Strata CTX system time. Night Transfer
Alternate Routing and Busy Station Identification do not require SMDI.
❐
For clock synch, you must configure the ksu_time parameter and connect SMDI.
❐
For Night Transfer Alternate Routing and Busy Station Identification, you must configure the console_slot_ID
and DSS_active parameters.
7
❐
Be sure to change the default password of the Shutdown Mailbox User ID 983 (see
Stratagy IVP8 or Stratagy DK Installation Guide).
❐
Don't forget to wear the anti-static wrist strap during handling.
❐
When using an internal modem in the Stratagy Admin PC, remember that Stratagy Admin does not work with
COM 3 or 4. Do not write over the Stratagy Admin subdirectory on your remote PC when installing the newer
version of Stratagy Admin. Always retain previous versions of Admin.
❐
Make sure your Strata I&M/Programming Manuals and Stratagy I&M Manuals are handy. Be sure to read
the entire Stratagy IVP8 or Stratagy DK Installation Guide before installing.
❐
Remember to back up your database after installation.
If you have read and completed this checklist, installation will be a breeze!
OK, let's get started!
page 40 in the
4011045