Table of Contents
Advertisement
7.
Component B dispensed volume will display. Com-
pare displayed volume with actual volume in con-
tainer B.
a.
For no change, press
b.
To change display, press and hold
to change display to match actual volume (left to
decrease, right to increase). Release
Ratio tolerance default value for meter-based sys-
tems is 5%. To change to a customized value, use
accessory Data Download Kit 248403 (IS) or
248404 (Non-IS) and follow instructions in manual
309623.
Set Meter K-factor
See manual 308778 for meter k-factor values.
1.
Open main air valve to start unit. Allow time for sys-
tem to boot up and display ratio setting.
2.
Turn function knob to A
3.
Hold down
(continue to hold until k-factor is set
in step 5). After 5 seconds, the default k-factor dis-
plays.
4.
Turn key to change k-factor (left to decrease, right to
increase).
5.
Release
to set k-factor.
309908G
, then release.
. Turn key
.
or B
.
Recalibrate Meter-based System
31
Advertisement
Table of Contents
