Table of Contents
Advertisement
Spraying
Spraying
1.
Close sampling valves H
A
B
valves G
and G
.
2.
Turn function knob to
3.
Trigger gun into a pail and slowly increase air regula-
tor pressure until pump is running and consistently
mixed material is dispensed.
24
A
B
and H
. Open shutoff
. Press
.
4.
Engage trigger lock. Press
5.
Follow Pressure Relief Procedure, page 14.
6.
Engage trigger lock. Install tip on gun.
7.
Adjust air regulator to the necessary spraying pres-
sure. Press
to proportion and spray.
8.
Follow Fluid Manifold Flushing, page 16, or Shut-
down, page 28, when you are done spraying or
before potlife expires.
Mixed material potlife or working time
decreases with increased temperature.
CAUTION
Do not allow the fluid supply tank to run empty. It is
possible for airflow in the supply line to turn gear
meters in the same manner as fluid. This can lead to
the proportioning of fluid and air that meets the ratio
and tolerance settings of the machine. This can fur-
ther result in spraying uncatalyzed material.
.
TI1948A
309908G
Advertisement
Table of Contents
